CALCULATORS / POWER CONVERSION AND SWITCHING

H-bridge current and loss budget calculator

Two conducting MOSFETs; RMS winding current supplied.

power-electronics-h-bridge.napkin / editable

SCENARIO COMPARISON

Compare the numbers.

This source describes an analytical model. Its quantities and checks are the view.

Scenario	conductionW
	1
	0.64

All calculated quantities are listed with the inputs. Switch to Source to inspect the equations.

SCENARIOS / CALCULATED VALUESSAME SOURCE

Change an input to see the consequences.

conduction loss budget1.00 W✓ passes

BASELINE INPUTS

current5 AonResistance0.02 ohm

CALCULATED

conduction1 W

Edits change the baseline source.

THE SOURCE

Edits below update the same model.

# H-bridge current and loss budget
# Scope: Two conducting MOSFETs; RMS winding current supplied.
# Status: illustrative worked example; engineering review pending.
# Inputs are example values. Checks are editable example requirements, not standards.

current = 5 A
onResistance = 0.02 ohm

conduction := 2*current^2*onResistance [W]

check conduction loss budget: conduction <= 2 W

scenario alternative: current = 4 A

Calculated from your source · not saved

Baseline · Baseline

conduction loss budget1.00 W ✓ passes

alternative · alternative

conduction loss budget0.64 W ✓ passes

Illustrative first-order example. Checks are editable requirements, not design standards. The broader topic may require additional equations, data, and validation.

Formula and units

This example uses the following equations. Input names and units match the editable source above.

conduction: conduction = 2*current^2*onResistance [W]

Original worked example

These are the baseline values in the downloadable source. Edits above let you test your own values.

Given

current: 5 A
on resistance: 0.02 ohm

Calculated

conduction: 1 W

Assumptions and limits

Two conducting MOSFETs; RMS winding current supplied.

The requirement checks use the limits written in this example. Passing a check does not establish that the model covers every load, material behavior, or operating condition in a real design.

Download this .napkin example ↓

Take it further with your agent

Napkin keeps the inputs, equations, checks and assumptions together in one study. Your agent sets it up; you change the numbers.

Try with Claude ↗

codex 'Use Napkin (https://napkin.engineering/mcp, or the local Napkin plugin) to build a study: H-bridge current and loss budget. Inputs: bus; load; device parameters; PWM. Outputs: device currents; losses; recirculation assumptions. Model scope: First-order switching models and explicit nonidealities. Read napkin_capabilities and the current snapshot. Ask me for the values that matter, label assumptions with units, author .napkin source, validate it and apply it with napkin_source using the current revision, then open the study. Add checks for the limits I supply. Keep unsupported analyses explicit.'

Claude needs the Napkin connector; Codex needs the Napkin plugin. Set up your agent ↗

The broader study

The topic brief below describes the broader scope. The worked example above states the particular calculation it implements.

Inputs: bus, load, device parameters, PWM
Outputs: device currents, losses, recirculation assumptions
Modes: calculate, compare, sweep
Drawing: Switching waveforms and loss plots

EXECUTABLE WORKED EXAMPLE · FIRST-ORDER MODEL · CHECK THE SCOPE & ASSUMPTIONS